HIGH BRIGHTNESS DISPLAY — RFQ / SPEC VERIFICATION CHECKLIST Companion to: High Brightness Monitor Buying Guide (apluslcd.com) Adapt the items to your project; delete what does not apply. Project: ____________ Date: ____________ Supplier: ____________ 1. BRIGHTNESS [ ] Rated luminance: ______ nits [ ] Center point / average / minimum across _____ points (state which): ______ [ ] Measured at thermal equilibrium: yes / no — ambient: ______ °C [ ] Warm-up time before reading: ______ minutes [ ] Brightness setting during measurement: ______ % (auto-dimming off: yes / no) [ ] Measured on bare panel or complete unit with cover glass + touch: ______ 2. UNIFORMITY [ ] Uniformity (min / max): ______ % [ ] Measurement grid: ______ points 3. THERMAL [ ] Hot-state luminance at ______ °C ambient after ______ minutes: ______ nits [ ] Automatic throttling threshold: ______ °C / ______ nits [ ] Max internal operating temperature: ______ °C — panel operating limit: ______ °C [ ] Cooling: passive / forced air / other: ______ 4. OPTICAL STACK [ ] Gap: air / OCR / OCA — adhesive: ______ [ ] Cover glass: AR / AG / none — reflectance ______ % — gloss ______ GU [ ] Touch layer: none / PCAP / resistive — transmission ______ % 5. RELIABILITY [ ] MTBF: ______ h — standard: MIL-HDBK-217F / Telcordia SR-332 — at ______ °C [ ] B10 life: ______ h [ ] Backlight L70 at target brightness and operating temperature: ______ h 6. PROTECTION [ ] Rating: ______ — front face only / whole unit (state which) [ ] Mounting cutout and tolerance: ______ — gasket material: ______ [ ] Cable entry and I/O protection: ______ [ ] Condensation management: drain / vent / none: ______ 7. PANEL, WARRANTY, SPARES [ ] Technology: IPS / VA / TN — viewing angle ______° / ______° [ ] Warranty: ______ years — backlight covered: yes / no [ ] Brightness depreciation threshold covered: ______ [ ] Spare backlight assemblies available: yes / no 8. SAMPLE VALIDATION [ ] Sample received: yes / no — identical to production configuration: yes / no [ ] My own measurement: ______ nits at ______ points, ______ °C, after ______ minutes [ ] Uniformity measured: ______ % NOTES ON USING THIS CHECKLIST - Record the measurement conditions next to every number. A luminance figure without ambient temperature, warm-up time, brightness setting and stack configuration is a claim, not a specification. - Compare only numbers taken under the same conditions. - Thermal figures (temperature rise, derating, throttling) are configuration-specific. Do not carry a value measured on one enclosure over to a different product or mounting. - Ingress ratings quoted as "IPxx front" cover the front bezel only; the rest of the unit depends on the host cabinet, cable glands and installation. - Acceptance thresholds belong to your application — set them per project and write down the conditions they apply to.